RAP4 T68 pistol question

[Ravenwood]

I have a T68 pistol and want to install the flex air through stock to it. I have the stock mounted on the pistol, but do not know to use the air through stock part? any help would be wonderful.

[Thalion]

Before you do anything, make sure it's not affected by the recall:

Recall Notice
Real Action Paintball Inc. (RAP4) has discovered a flaw in two out of the three styles of our Remote Line Adaptors, as shown in the pictures on the following page. These Remote Line Adaptors, also known as Solid Remote Line Adaptors, are part of the Flexi-Air System for all T68 models and certain RAP4 models, as well as Spyder, Tippmann, Storm, and BT paintball markers. If this system fails, it may accidentally burst and may cause serious injuries.

Affected Systems:
The two flawed Remote Line Adaptor models for the Flexi-Air System are similar except that one has an end cap with plug and the other has an end cap with a remote line quick connect male adaptor.

http://rap4.com/rc/RAP4--Recalled-Flexi-Air-System.JPG

There were approximately 2000 units distributed between September 1, 2006 and May 14, 2008. If you have purchased these Flexi-Air Systems or markers that come with affected Flexi-Air System components, please stop using the system and contact us at (800) 404-9029 or go online at http://www.rap4.com/rc/ to submit your information for an exchange. Once we have received your contact information, we will issue a call tag/return label for your Flexi-Air System and process the exchange accordingly.


See also:

http://forum.specialopspaintball.com/index.php?showtopic=151253

http://forum.specialopspaintball.com/index.php?showtopic=150966


As for actual installation of the air-through section, I'd have to take a look at it. Unfortunately, RAP4 manuals aren't the best (Shaman can agree to that tongue:) ), and since I've never worked on one yet, I'd have to see it.

[Ravenwood]

Thanks Thalion, I already have had it replaced by RAP4 but thanks for the warning. I am off work tomorrow so will play around with it and try to figure it out lol.

[Thalion]

I've been thinking...

The T68 pistol takes 12 grams, right?

Do you have a "12 gram dummy" in this kit?

If so, you could run a line from the dummy to the stock, then a remote line to the stock.

If there's some way to get air through the backside of the gun, I have no clue how to get that done without looking at it.

[Shaman]

Thalion is right about the 12 gram dummy, those work well, pretty sure you can buy one if it is not in the kit.

There is also a RAP4 owners group that can help with the pistol questions if you cannot find the answer.

Their forums are here:

http://rap4.com/paintball/forum/