Response Trigger 98c

[SAWyer249]

There is no help section on this forum so i have a question:

i recently installed the response trigger with the cyclone feed on my 98c and dang thing won't work. when i fire i get the "out of air" sound. i know i wasn't out of air...
could it be something with my hoses or could it be something with the actual cylinder?

please respond kindly i'm kinda a newbie...sort of kinda.

[AKA]

Well, without having a look at it, you'll probably not like my suggestion but I'll offer it anyway. Tear it down and start all over.;) If you don't have an air leak when your aired up then your hoses and connections should be fine. Recheck your "O" rings and make sure they're dry. Then check to make sure your sear spring did'nt disconnect when you pinned it back in place. Also ckeck to see if the rear spring did'nt double-up on the re-cock. As for the response, make sure all the tiny "O" rings are in the right places and not obstructing any air passages. Other than that, make sure your ball detent is facing the right way!:D/AKA

[SAWyer249]

oh man...tear it down :( oh well whatever gets it work i guess. thanks man