68 carbine in a stock

[JJohnson]

Just finished this up today. For some reason I felt the need to make a stock class feed tube for it even though it's semi-auto:rolleyes:

http://i74.photobucket.com/albums/i254/Envoyofchaos/100_2039.jpg

Stock class! Except the whole semi-auto part of it...tongue:)

http://i74.photobucket.com/albums/i254/Envoyofchaos/100_2041.jpg

http://i74.photobucket.com/albums/i254/Envoyofchaos/100_2036.jpg

http://i74.photobucket.com/albums/i254/Envoyofchaos/100_2045.jpg

Probably the configuration I will usually use with it whenever I decide to play a few games with it (but obviously with the Stiffi instead of the massive Rap4 barrel). Maybe I'll pick up a 3.5oz CO2 over the winter and lose the remote line.

http://i74.photobucket.com/albums/i254/Envoyofchaos/100_2050.jpg
Didn't focus on the stock, but you can see the two screws that are holding the stock to the gun. Also made an existing screw hole a little bigger in order to be able to get at the velocity adjustment screw.

Aside from the feed tube, I just had to make one aluminum part on the mill to hold it together.

[wicker77]

Wow, very nice, looks awesome :)

[Ish]

Looks nice.

[Sarge]

What'd you use for the body? I've been looking to do the same with a different gun.

[JJohnson]

What'd you use for the body? I've been looking to do the same with a different gun.

Cannibilized my old crossman pellet gun (http://www.airgunsbbguns.com/Crosman_1077_CO2_Semi_Automatic_Air_Rifle_p/cro1077.htm). Had to do some dremiling on it, but not near as bad as when I fit an MR1 into an airsoft g36 body.